Spracht Cell Phone Accessories User Manual

User Guide ERRATA

4.PairingtheAuraMobileBT™withaMobilePhone

• Make sure that your AMBT™ is powered on.

• Power on your Bluetooth® enabled mobile phone.

• To switch to Bluetooth® mode and connect to a

Bluetooth® mobile phone, press and hold the

Mode button

until a chime sounds. Release

• Press and hold the Mode button on your AMBT™.

DO NOT release the Mode button until you hear

a two note chime. The “Bluetooth” indicator will

flash BOTH blue and amber. The AMBT™ is now

ready for pairing.

NOTE: If no connection is established with a Bluetooth®

mobile phone within 60 seconds, the AMBT™ will switch

to idle mode, signaled by a flashing amber “Bluetooth”

light. In this case, you must hold the

seconds until the “Bluetooth” light flashes blue and

a tone sounds. Next, hold the button once again

button for 3

until the “Bluetooth” light flashes both blue and amber.

• Follow your mobile phone’s instruction guide to

connect to a Bluetooth® device. Typically, you will

clickonaBluetooth®iconandclick“Discoverdevice.”

• Your mobile phone should find the AMBT™ which is

displayed as “BTHS”.

• Click on“BTHS”and click“OK”if your phone prompts

you to confirm.

• Your mobile phone will then prompt you to enter a

PIN or password. Enter: 0000

• If the pairing is successful, your mobile phone will